E 320 4MATIC Wagon (210.282) V6-3.2L (112.941) (1998)
Note:
^
The (fixed) installation position of the harmonic balancer pulley (5) on the crankshaft is specified by the parallel (woodruff type) key
installed on the crankshaft (refer to WIS: GF03.30-P-1600-01C).
^
Lubricate the harmonic balancer pulley bolt head (4) contact surface (where bolt head contacts pulley) with clean engine oil.
^
Torque harmonic balancer bolt (4) in two stages:
First torque bolt to: 200 Nm then turn bolt 95°.
C.
ENGINES 112 AND 113 WITH ELECTRIC ENGINE FAN
1.
Remove front air filter cover or engine cover as necessary.
2.
Remove electric fan (1 Figure 3) and fan shroud (3):
^
Model 163: refer to WIS: AR20.40-P-5000GH
^
Models 208: remove clips securing fan to radiator, disconnect fan harness connector, remove fan (1) and shroud (3) as an assembly.
^
Model 170: refer to WIS: AR20.40-P-5000SV.
3.
Remove engine belt (2):
^
Model 163 refer to WIS: AR13.22-P-1202BA
^
Models 208, 210, 215, 220 refer to WIS: AR13.22-P-1202BA
^
Model 170.465 refer to WIS: AR13.22-P-1202SV.
^
Special tool: external torx set W001 589 76 09 00
Note:
Replace engine belt only if belt is damaged due to a deteriorated harmonic balancer pulley. Replacement of belt due to normal wear may not be
claimed under this campaign.
4.
Remove harmonic damper pulley bolt (4):