E 320 BLUETEC (211.022) V6-3.0L DSL Turbo (642.920) (2007)
3
Remove brake hose (51)
4
Disconnect electrical connector of right rear brake pad contact sensor (S10/4)
CAUTION: See note on installing contact sensor for brake lining wear indicator
5
Detach electrical feed line of right rear brake pad contact sensor (S10/4) from floating brake caliper
NOTE: To do this, unscrew bolt (36).
6
Removing rear axle brake pads
7
Unscrew bolts (35) and take off floating caliper carrier
NOTE: Installation: Replace bolts (35).
8
Install in the reverse order
9
Bleed brake system.
10
Activate SBC brake system using STAR DIAGNOSIS.
11
Use STAR DIAGNOSIS to move brake pads toward brake disks