mercedesbenz Workshop Repair Guides

Mercedes Benz Workshop Service and Repair Manuals

Campaign - Check Routing of Brake Lines|Page 12626 > < Campaign - Check Routing of Brake Lines|Page 12620
Page 1
background image

Brake Hose/Line: All Technical Service Bulletins
Campaign - Check Routing of Brake Lines

Campaign No. 2006110007, December 2006

FILE:
SERVICE: GROUP 00 OF SERVICE INFORMATION BINDER
PARTS: GROUP I OF INFORMATION _ PARTS & ACCESSORIES BINDER

TO: ALL MERCEDES-BENZ CENTERS

SUBJECT:

MODELS 211, 219  MODEL YEAR 2007

CHECK ROUTING OF BRAKE LINES AND INSTALL CHAFING PROTECTION IF NECESSARY

This Service Campaign has been initiated because DCAG has determined that on affected vehicles  (see VIN range) tolerance deviations may have
occurred in the installations of the brake lines which can lead to minimal chafing of the brake lines on the fender liner. The dealer will check the brake
line routing and install chafe protection if necessary.

Please review the Effective Serial Number chart located on the following page, and if necessary, repair the subject vehicles during the vehicle's next
service.

Prior to performing this Service Campaign:

-

Please check VMI to insure the vehicle is involved and to determine if the vehicle has been previously repaired.

-

Please review the entire Service Campaign bulletin.

Approximately 979 vehicles are affected.

Effective Serial Number Range

NOTE:  

Every vehicle in the VIN range may not be included in the campaign. VMI must always be checked before performing campaigns to verify that the
campaign is required on a specific vehicle. VMI always overrides the bulletin in reference to a specific vehicle's inclusion in a particular campaign.
Please also note that Recall and Service Campaigns do not expire and may also be performed on a vehicle with a vehicle status indicator.

Procedure

1.Check distance between brake lines (A, Figure 1) and body panel (B) at all three brake lines near the ABR hydraulic unit, as shown in Figure 1.

-

If distance is 5 mm or greater, this campaign has been completed.

-

If distance is less than 5 mm, proceed to next step.

Campaign - Check Routing of Brake Lines|Page 12626 > < Campaign - Check Routing of Brake Lines|Page 12620