E 320 BLUETEC (211.022) V6-3.0L DSL Turbo (642.920) (2007)
^ Close locking catch (3) again.
8. Connect plug housing (4) with connector (5) of repair wiring harness.
^ The plug must click into place.
9. Screw cable lug (6) of repair wiring harness onto ground (right front) (W2) and/or ground (left front) (W9).
10. Install turn signal lamp socket (E1e5, E2e5) in headlamp housing.
11. Connect electrical connector (2) to headlamp housing.
^ Ensure that the seal is properly seated in the electrical connector (2).
12. Fasten repair wiring harness along original wiring harness with two tie straps.
^ Fasten so as to prevent noise.
13. Connect ground cable to on-board electrical system battery.
^ Model 211.0 AR54.10-P-0003T
^ Model 211.2 AR54.10-P-0003TA
14. Perform function check of lighting system.
Attachments
Symptoms