E 320 BLUETEC (211.022) V6-3.0L DSL Turbo (642.920) (2007)
Windshield Washer Pump: Service and Repair
AR82.35-P-6002T Remove/Install Windshield Washer System Pump
1
Disconnect ground cable of battery
DANGER:
-
Risk of death. Death may result if vehicle slips or topples from the lifting platform.
-
Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified
by the vehicle manufacturer.
2
Lift vehicle on lifting platform.
3
Remove right front wheel
-
Wheel bolt:130 N.m
4
Remove rear fender liner in right front fender
5
Disconnect electrical connector (1)
6
Disconnect electric connector (2)
7
Disconnect the washer fluid hose from the windshield washer fluid pump (M5/1)
NOTE: Collect washer fluid which flows out.
8
Unclip bracket (4) from washer fluid reservoir (5)
9
Use a mounting wedge to push off the windshield washer fluid pump (M5/1) from the washer fluid reservoir (5)
NOTE:
-
Note correct installation position.
-
Installation: Install new gasket (6)
See "Special Tools" given below.
10
Install in the reverse order
11
Fill washer fluid reservoir (5)
12
Perform function check on windshield washer system
NOTE: Switch on the ignition and press the combination switch to check the function of the windshield washer fluid pump (M5/1). A sufficient
quantity of washer fluid must exit at the washer nozzles.
Special Tools