E 320 CDI (211.026) L6-3.2L DSL Turbo (648.961) (2005)
/l6-3.2l_dsl_turbo_(648.961)/Page-4174014.png)
In export countries the respective licensing provisions or legal requirements for the installation of a trailer hitch must be observed.
The body sealant and underfloor protection must be removed from all the body mounting points of the trailer hitch. The mounting points should then be
cleaned with a commercially available cleaning agent. Apply anticorrosion paint to bare-metal areas of the body.
Trailer couplings are homologated safety parts. Their installation on the vehicle is to be carried out exclusively by trained, professional technicians.
Trailer couplings, which are damaged because of an accident, bottoming or being run into from behind, must be replaced; subsequent alterations such as
bending, mechanically processing, and welding are not permitted.
The coupling ball must have a minimum diameter of 49 mm at all points, measured using a caliper gauge. The ball must be greased before use to reduce
wear. Advise the customer accordingly.
On trailers with an anti-swerve device it is not necessary to grease the ball (refer to trailer instructions). Advise the customer accordingly.
Advise the customer to read the "Trailer coupling" and "Towing a trailer" sections in the vehicle owner's manual.
On some models the electric fan must be replaced with a more powerful electric fan.
Failure to retrofit this component will render the warranty/goodwill warranty invalid.
Check that the reinforcements are installed in the trunk on the left (6) and right (7). If not, the reinforcements must be retrofitted.
In the event that the above-mentioned components are not retrofitted, this will render the warranty/goodwill null and void
AH31.19-P-1000-01T Notes on The Operation of Voltage Supply, Terminal 15R
AH31.19-P-1000-01T Notes On The Operation Of Voltage Supply, Terminal 15R
- 211.026/065/070/082/083 1#
- with CODE (550) Trailer hitch
- except CODE (772) AMG styling package - front spoiler, side skirts and rear apron
At the voltage supply, terminal 15R, only a maximum of 15A consumers may be operated.
The voltage supply, terminal 15R, may not be used for charging a battery.
