E 320 CDI (211.026) L6-3.2L DSL Turbo (648.961) (2005)
Height setting
-
Measuring position "A" (x):140 mm
-
front and rear: deeper than the outer roof surface: 0 - 1 mm
10
Tighten bolts (5) of sliding/pop-up roof panel (3)
-
Bolt of sliding/pop-up roof panel to pop-up angle bracket: 4 N.m
NOTE: First of all tighten the respective rear bolt and then the front bolt.
11
Check sliding/pop-up roof for proper function and fit
12
Move sliding/pop-up roof to pop-up position
13
Insert rubber bellows (4) on both sides at top and bottom in the guide
14
Close sliding / pop-up roof
15
Open sliding/pop-up roof approx.20 cm
16
Install covering (2)
NOTE: Position covering (2) in center and clip on.
17
Close sliding/pop-up roof
18
Push paneling (1) toward front
19
Perform teach-in procedure for sliding roof obstruction sensor
Special Tools
Assembly Wedge, P/N # 110 589 03 59 00