E 320 CDI (211.026) L6-3.2L DSL Turbo (648.961) (2005)
NOTE: Installation: Install new retaining clips (85a).
6
Unclip front brake cable (85) from bridge (70)
7
Remove front left floor covering
8
Remove retaining clips (85a) in driver footwell
NOTE: Installation: Install new retaining clips (85a).
9
Remove supporting wedge (17)
10
Unhook front brake cable (85) from tensioning shackle (85b)
NOTE: Installation: Ensure rubber ring (85c) is installed in correct position in tensioning shackle (85b).
11
Unclip front brake cable (85) from pedal assembly (71)
12
Lever grommet (85d) out of propeller shaft tunnel and pull front brake cable (85) into passenger compartment
NOTE: Installation: Push front brake cable (85) outwards from inside the passenger compartment.
13
Install in the reverse order
Inspect
14
Check version of pedal assembly (71)
15
Operate parking brake pedal and check pedal travel of parking brake pedal
NOTE:
-
If the pedal travel is not within the tolerance range then adjust parking brake
-
Control force on parking brake pedal
-
Number of notches that parking brake pedal has to be pressed