E 320 CDI (211.026) L6-3.2L DSL Turbo (648.961) (2005)
/l6-3.2l_dsl_turbo_(648.961)/Page-2869001.png)
Fuse Block: Service and Repair
AR54.15-P-1257T Remove/Install Fuse and Relay Box In Engine Compartment
AR54.15-P-1257T Remove/Install Fuse and Relay Box In Engine Compartment
1
Remove left front SAM control module with fuse and relay box
2
Remove injection system control module
3
Remove cable duct seal (2)
4
Lift right wiring harness (3), disconnect electrical connector (6) and move right wiring harness (3) to one side
NOTE: Installation: Observe routing of electrical cables.
5
Lift left wiring harness (5) and remove control module box blower motor (M2/2) as well as from the fuse and relay box (F1) until the electrical
connector on the control module box blower motor (M2/2) is accessible
