mercedesbenz Workshop Repair Guides

Mercedes Benz Workshop Service and Repair Manuals

Charging System - Voltage Regulator Inspection/Testing|Page 13078 > < Instruments - False Messages Displayed|Page 13073
Page 1
background image

Voltage Regulator: Technical Service Bulletins
Charging System - Voltage Regulator Inspection/Testing

Date: May 2007

Order No.: S-B-15.40/58a

Supersedes: S-B-15.40/58, P-B-15.40/56, T-B-15.40/57

Group: 15

MODELS

SUBJECT:
Test and Inspection of Charging System Regulator

Revision History

Revision

Date

Purpose

A

03/07

Additional of models 164.122/822/871, 211.022, 251.122, 230, 463, and warranty coding information

-

05/05

Initial issue

During testing of returned alternators (that were replaced under warranty) it has been determined that many alternators are being replaced when only the
(replaceable) regulators are found to not be functioning. Therefore, in the event a charging system test determines the need to replace a nonfunctioning
regulator; replace the regulator (independently from alternator).

Note:

Regulators installed on water cooled alternators and those installed on model 199 alternators are not replaceable.

For regulator test and inspection instructions refer to Subject A.

A. Test and inspection of charging system regulators

1.

Refer to Subject B for charging system testing instructions.

2.

For instructions on replacing nonfunctioning regulators for models:

^

163 refer to Subject C

^

203 4Matic, 211 4Matic, 215, 220, 463 refer to Subject D

^

203/208/209/211/219/230 refer to Subject E (does not include 4Matic models).

^

129/164/170/171/202/210/221/251, and models not listed above (that are included in this Bulletin) refer to WIS group: 15.40.

Note:

(when referring to WIS instructions for replacing regulator) Ensure non functioning regulator is inspected (refer to Subject F, step 3) prior to
replacing. Ensure circuit 30 systems are reinitialized and fault codes are erased (refer to refer to Subject F, steps 8 and 9).

3.

After removing a regulator that has been tested and found to be not functioning, it must be visually inspected (refer to Subject F, step 3) to
determine the condition of the alternator bearing.

B. Alternator Diagnosis

Charging System - Voltage Regulator Inspection/Testing|Page 13078 > < Instruments - False Messages Displayed|Page 13073