E 320 CDI (211.026) L6-3.2L DSL Turbo (648.961) (2005)
- except CODE (Z06) B6 armoring
- except CODE (Z07) Top protection
- except 4-MATIC
Component Identification
1
Set the fender flange in several stages in the marked area (B).
Use a plastic mallet to avoid damaging paint.
Carefully heat outer edges of fender to max. 70 to 80 degrees C using a hot air blower.
Do not overheat paint when heating up (maximum 80 degrees C). Repair any damage to the paint
2
Check tire clearance with a fully compressed rear axle and of necessary intensify the rework.
3
When the rear axle is compressed, check the clearance between the tire and rear apron end face or wheelhouse insert (in the region of the transition
rear apron/side piece).
If necessary make the clearance by reworking.
4
Re-preserve wheel housing with underfloor protection and spray the repositioned fender edges with cavity preservation.
AZ40.10-P-0003T Retrofit AMG Light Alloy Wheels
AZ40.10-P-0003T Retrofit AMG light alloy wheels
- except CODE (Z04) Light armoring
- except CODE (Z06) B6 armoring
- except CODE (Z07) Top protection
- except except 4-MATIC
- with CODE (489) Airmatic (semi-active air suspension_
- with CODE (950) AMG sport package
- with CODE (952) Sport package
- with 4-MATIC