E 320 CDI (211.026) L6-3.2L DSL Turbo (648.961) (2005)
/l6-3.2l_dsl_turbo_(648.961)/Page-2191010.png)
Measurement values screen for angle 3: display e.g. 2.76 degrees
Confirmation screen
A confirmation message appears briefly.
Confirmation screen
Ready screen for angle 4
The meter then indicates that it is ready to measure the next angle (angle 4).
8
Remove sensor (020a) from rear propeller shaft (2).
Ready screen for angle 4
AR41.10-P-0085-03T Measure Absolute Angle at Rear Axle Housing
AR41.10-P-0085-03T Measure absolute angle at rear axle housing
Measurement - Angle 4
The vehicle must be on its wheels for the measurement. All four angles should be measured in succession without interruption.
An angle that has already been measured can be measured a second time if required. To do this, with the Measurement menu displayed, press the
STEP button repeatedly until the display indicates Ready to measure the relevant angle.
