E 320 CDI (211.026) L6-3.2L DSL Turbo (648.961) (2005)
2
Knock centering sleeve evenly out of propeller shaft (arrow) using a flat chisel.
Component Identification
If it is not possible to hammer out the centering sleeve using a chisel:
3
Drill a hole (dia. 10 mm) 15 mm from the end face of the centering sleeve (10) at right-angles through the centering sleeve.
Component Identification
4
Insert a drift through the bore and lever the centering sleeve (10) out of the propeller shaft using two assembly levers.