E 320 Coupe (124.052) L6-3.2L (104.992) (1994)
1
Remove self-locking hex. nut (7a) and detach connecting rod (7).
Installation Note
If a new connecting rod has been installed, check and adjust vehicle level. Replace self-locking hex. nut, 10 Nm.
Model 124 in bore "b"
2
Detach linkage (7) from torsion bar lever (arrow) and remove.
Installation Note
Replace self-locking hex. nut, 10 Nm.
3
Check ball joint on connecting rod for ease of movement and wear.
Note:
It must not be possible to pull ball pin out of ball socket.
4
Install in reverse sequence.