E 320 Coupe (124.052) L6-3.2L (104.992) (1994)
/l6-3.2l_(104.992)/Page-1391001.png)
Control Pressure Cable: Service and Repair
Vehicles With Program Selector Switch
Control pressure cable lock (arrow)
Unscrew with a screwdriver and detach from connecting rod (110). Remove transmission oil pan to install. Hook connecting rod (110) onto
control pressure cable (98). Feed limiting rod (111) into bore (arrow) and insert control pressure cable. Rotate control pressure cable until lock
engages.
Tester (02) 201 509 13 21 00
Connect to vacuum actuator and apply vacuum. Pull control pressure cable as far as full-load stop.
Distance "a"
Measure between front face of control pressure valve (46) and closure plate (84). Specified value: 8 mm on 4-cylinder engines. 6 mm on
6-cylinder engines. Adjust distance "a" as necessary with hexagon socket bolt (arrow).
Special Tool
NOTE: Phased in as of 07/93. a standardized control pressure cable has been fitted in the body. The control pressure cable with 2 vacuum actuators in
the plastic housing is also used for the transmission which does not need the two vacuum actuators.
