E 320 Sedan (211.065) V6-3.2L (112.949) (2004)
Sunroof / Moonroof Drain: Service and Repair
AR77.20-P-1999T Remove/Install Water Drain Trough on Sliding/Pop-Up Roof
AR77.20-P-1999T Remove/Install Water Drain Trough on Sliding/Pop-Up Roof
- with CODE (414) Power glass tilting/sliding roof
Shown On Model 211.0
DANGER:
-
Risk of injury to fingers being jammed or squeezed when removing and installing or aligning hoods, doors, trunk lid/tailgate or sliding
roof.
-
When moving components, ensure that no body parts or limbs are within the operating range of moving parts.
1
Push paneling (1) toward rear
2
Open sliding/pop-up roof approx. 20 cm
3
Unclip covering (2) in center and on side with assembly wedge (6), guide covering (2) out of rubber bellows (4)
See "Special Tools" given below.
NOTE: Installation: Position covering (2) centrically and clip on.
4
Move sliding/pop-up roof panel (3) in pop-up position
5
Detach rubber bellows (4) on both sides at top and bottom and remove
CAUTION: Carefully handle rubber bellows (4), otherwise it could be damaged.
NOTE: Note correct installation position.
6
Press water drain channel (5) on both sides with long wedge (7) out of pop-up bracket (8) and lift out
NOTE: Push in water drain channel (5), on passenger side, between paneling (1) and roof paneling, pull out on driver side and remove.
See "Special Tools" given below.
7
Install in the reverse order
8
Perform teach-in procedure for sliding roof obstruction sensor
Special Tools