E 320 Sedan (211.065) V6-3.2L (112.949) (2004)
Air Bag Harness: All Technical Service Bulletins
Restraints - SRS Lamp ON/Codes 9103/9123 Set
Date: March 4, 2009
Order No.: P-B-91.60/99e
Supersedes: P-B-91.60/99d dated June 12, 2007
Group: 91
Revision History
Revision
Date
Purpose
e
3/4/09
Warranty Information Updated
d
6/12/07
Notes Added for Short Test and Returned Parts
c
2/6/07
Applicable Models / Part Numbers / Work Instruc. and Warranty Info. Updated
b
4/13/06
Numbering Sequence Corrected - No Change to Content
a
1/17/06
Process, Part No. Description and Damage Code Update
-
12/12/05
Initial issue
SUBJECT:
Model211.022/026/056/065/070/072/076/077/082/083/087/090/256/265/276/277/
282/283/287
Model 219.372/375/376/377
SRS Light Illuminated
If you receive customer reports in the above model vehicles of the SRS light being illuminated accompanied by either of the diagnostic fault codes listed
below, perform the following procedure.
Note:
Replacement of the contact spiral is not necessary for this repair procedure. Returned contact spirals will be subject to testing and may be debited if
found to be operational.
Fault Codes:
DTC 9103 - the resistance value in the ignition circuit containing component R12/13 is too high
DTC 9123 - the resistance value in the ignition circuit containing component R12/14 is too high
Note:
Short test printout from STAR Diagnosis required to be sent with returned connectors.
1. Remove the Steering Column Module (SCM). Refer to WIS document AR54.25-P-2802T(A) (211) or WIS document AR54.25-P-2802TX (219).
2. Disconnect battery ground cable. Refer to WIS document AR54.10-P-0003T(A) (211) or AR54.10-P-0003TX (219).
Note:
The battery ground cable must be disconnected. If this step is omitted, other faults may be introduced into the vehicle when cutting the SCM harness.
3. Remove instrument panel bottom section on driver's side. Refer to WIS document AR68.10-P-1505T (211) or AR68.10-P-1505TX (219).