E 320 Sedan (211.065) V6-3.2L (112.949) (2004)
Shown On Model 230.474
DANGER:
-
Risk of death, Death may result if vehicle slips or topples from the lifting platform.
-
Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points
specified by the vehicle manufacturer.
1
Remove engine compartment paneling
NOTE: Only rear part.
2
Drain and collect engine oil
NOTE: Oil drain plug to oil pan
3
Disconnect electrical plug socket at oil sensor (oil level, temperature and quality) (B40)
4
Unscrew bolts (40/1)
5
Remove oil sensor (oil level, temperature and quality) (B40)
NOTE: Installation: Replace O-ring.
6
Install in the reverse order.
7
Check engine oil level approx. 5 minutes after switching off the warm engine, if required adjust to correct level
CAUTION: The vehicle must be positioned horizontally on its wheels, otherwise this could lead to a distortion of the measurement result.
NOTE: Model 230: Inquire about engine oil level via the multifunction display, refer to Operating instructions.