E 320 Wagon (124.092) L6-3.2L (104.992) (1994)
/l6-3.2l_(104.992)/Page-640002.png)
Procedure
1. On all Models, record radio settings and disconnect ground cable at battery.
Installation Note: Encode radio, model 140 normalize power windows.
2. Remove intake air scoop.
3. On Model 124, 129, remove fan cover ring by withdrawing locking pin and turning ring to the left. Place ring on the fan.
Installation Note: Ensure that the four engaging points are correctly located.
4. On all models, remove fan cowl.
5. Remove bottom engine compartment panel
6. Drain engine oil (approx. 7.0l).
Replace gasket.
Install oil drain plug.
7. Unscrew bolts on left and right engine mounts (a) from below.
On Model 140, unscrew nuts (b) of the torsion bar, lower torsion bar.
On all models, replace self-locking nuts.
8. Detach connector of oil level switch on left of oil pan.
9. Detach oil pressure connector so that it is not damaged when raising the engine.
10. Unscrew transmission oil cooler pipes from oil pan.
11. Unscrew engine oil cooler pipes from oil pan.
12. On model 124 and 129, remove torsion bar.
On model 140, lower torsion bar.
13. On Model 124 and 129, attach engine hoist to front lifting lug.
14. Unscrew drag link on left and steering damper on right, detach.
15. Turn drag link to the rear right.
16. On Model 140, raise engine with engine supporting bar.
CAUTION: Raise engine only far enough for cylinder head to be resting against component compartment wall.
17. Remove springs of front axle, install.
