E 320 Wagon (124.092) L6-3.2L (104.992) (1994)
Intake Manifold: Service and Repair
Remove/Install Ram Manifold
Intake manifold with mount for intake noise muffler
Prerequisite: resonance intake manifold removed. See: Remove/Install Resonance Intake Manifold
1
Remove control cable from bracket of throttle control lever (32/3).
2
Take off ram manifold.
a. Models with oil-to-water heat exchanger: unscrew bolt at the resonance intake manifold from the pipe fixture with spacer sleeve.
b. Models with oil cooler: unscrew bolt from the oil pipe fixture.
NOTE: Replace ram manifold, if necessary. To do this, remove all the parts attached to the ram manifold and fit onto new ram manifold. Replace
gaskets.
3
Install in reverse sequence.
NOTE: When installing, ensure that no vacuum pipes or electrical wiring is trapped.