E 320 Wagon (211.265) V6-3.2L (112.949) (2003)
3
Remove pressure and intake line (2, 3) from expansion valve (1
NOTE: Seal the openings in the suction line (2) and pressure line (3), otherwise there may be an ingress of dirt or moisture.
-
Set of plugs for air conditioning system.
See "Commercially Available Tools" given below.
NOTE: Installation: Replace sealing rings and moisten thread with compressor oil.
4
Removing heat exchanger shutoff motor
NOTE: Seal heating water lines to heat exchanger.
-
Set of plugs for air conditioning system.
See "Commercially Available Tools" given below.
5
Remove cross member below instrument panel
6
Pull evaporator housing (5) to rear, lift and simultaneously move out of rear footwell air ducts (8)
NOTE: Installation: Insert evaporator housing (5) into lightly greased pilot studs (6) attached to body.
7
Unclip electrical wiring harness (arrow) at the top of the AC housing (5)
8
Press the floor covering on the transmission tunnel to one side and pull off the condensate drain hoses (7) on the left and right of the AC housing
(5)
NOTE: Installation: Pay attention to the correct seating of the condensate drain hoses (7) on the AC housing (5) and transmission tunnel,
otherwise the condensate cannot drain outwards.
-
Use lubricant
9
Remove evaporator housing (5)
NOTE: Installation: Use new seals between the AC housing (5) and body.
10
Replace receiver/drier
11
Install in the reverse order.
Commercially Available Tools
Commercially Available Tools