E 320 Wagon (211.265) V6-3.2L (112.949) (2003)
1.
Connect SDS to vehicle through the 16 pin diagnostic connector (X11/4).
2.
Software test CGW:
^
Navigate through the following screen menus in DAS to perform software test: Control units/Body/Central gateway/Control unit version.
^
An update must be performed for software with "MB object number for software" (bottom arrow, Figure 1): A211 445 20 00 A211 445 24 00
or A211 445 25 00, Software status" (top arrow) 03380 is displayed (refer to Subject B [Flash procedure] to perform update).
Note:
An update is not required for other MB object numbers or a different software release.
B.
Flash procedure
Note:
Preflash requirements:
^
Battery voltage >11 volts
^
Connect battery charger
1.
Data back-up
Menu item "Information and Communication":
^
Navigate through the following screen menus in DAS: Control units/Information and Communication/ASSYST:
Print out: Actual values/Active service system since the last oil change.
^
Navigate through the following screen menus in DAS: Control units/Information and Communication/ASSYST PLUS:
Print out:
a) Actual values/CAN reception data
b) Actual values/Internal ASSYST PLUS data.
c) General servicing/Service memory