E 320 Wagon (211.265) V6-3.2L (112.949) (2003)
NOTE: To do so unlock the retainer tab on the electrical connector (8) and remove the electrical connector (8) downwards from the washer fluid
reservoir (6)
10
Unclip bracket (5) from washer fluid reservoir (6)
11
Use a mounting wedge to push off the windshield washer fluid pump (M5/1) from the washer fluid reservoir (6)
-
Only applies where the windshield washer fluid pump (M5/1) is removed.
See "Special Tools" given below.
NOTE:
-
Note correct installation position.
-
Installation:Replace gasket (7)
12
Use a mounting wedge to push off the rear-end door washer fluid pump (M5/3) from the washer fluid reservoir (6)
-
Only applies where the rear-end door washer fluid pump (M5/3) is removed.
See "Special Tools" given below.
NOTE:
-
Note correct installation position.
-
Installation: Replace gasket (7)
13
Install in the reverse order
14
Fill washer fluid reservoir (6)
15
Perform function check on windshield washer system
NOTE: Switch on the ignition and press the combination switch to check the function of the windshield washer fluid pump (M5/1). A sufficient
quantity of washer fluid must exit at the washer nozzles.
16
Perform function check on rear washer system
NOTE: Press the rear wiper switch to check the function of the rear-end door washer fluid pump (M5/3). A sufficient quantity of washer fluid
must exit at the washer nozzles.
Special Tools
Assembly Wedge, P/N # 110 589 03 59 00