E 320 Wagon (211.265) V6-3.2L (112.949) (2003)
Shown on model 211.2, rear-end door wiper arm (1) in parked position
2
Clamp adapter (C) with angle measuring device (A) by tightening the knurled bolt (2) at the head of the rear-end door wiper arm (1).
3
Lower rear-end door wiper arm (1) until all three contact points of the angle measuring device (A) foot are lying against the rear window.
4
Read angle of incidence of rear-end door wiper arm (1) from scale of angle measuring device (A) and note down.
5
Raise rear-end door wiper arm (1) and remove angle measuring device (A) with adapter (C).
6
Fit wiper blade.
See operator's manual.
7
Switch ignition on (circuit 15 or circuit 15R), allow rear-end door wiper arm (1) to run to parked position and switch ignition off again
8
Fit angle measuring device (A) with adapter (C) to rear-end door wiper arm (1).
9
Read off angle of incidence of rear-end door wiper arm (1) from scale of angle measuring device (A), note down and compare with test and
adjustment values.
10
Raise rear-end door wiper arm (1) and remove angle measuring device (A) with adapter (C).