E 350 4MATIC Sedan (212.087) V6-3.5L (272.977) (2010)
Confirmation Screen
A confirmation message appears briefly.
Confirmation screen
Ready Screen For Angle 3
The meter then indicates that it is ready to measure the next angle (angle 3).
4
Remove sensor (020a) from front propeller shaft (1).
Ready screen for angle 3
Measurement - Angle 3: rear propeller shaft
Component Identification
5
Clean contact surfaces for sensor (020a) on rear propeller shaft (2).
6
Position sensor (020a) horizontally on rear propeller shaft (2) and press on firmly.
The spiral cable (020b) of the sensor (020a) must point in the direction of travel for each measurement. Otherwise the measurement will be
inaccurate. If the sensor (020a) is not positioned horizontally on the rear propeller shaft (2), the error message "Y-positional error - sensor ??"
appears on the display. The measured angle cannot be saved.