E 420 (210.072) V8-4.2L (119.985) (1997)
Sunroof / Moonroof Panel: Adjustments
AR77.20-P-1100M Adjusting Tilting/Sliding Roof Panel
Removing, installing
1
Push lining to rear
2
Open tilting/sliding roof approx. 10 cm
3
Remove cover (2)
NOTE: Push cover (2) away on the outside using a plastic wedge (see arrow) before pulling off.
4
Move tilting/sliding roof to tilt position
5
Remove rail (3) from rubber bellows (4) in direction of arrow
CAUTION: Unclip the rail at the front first.
6
Detach rubber bellows (4) from tilting/sliding roof panel (1) to gain access to the torx bolts (5)
CAUTION: Do not damage the rubber bellows.
Adjusting
7
Close tilting/sliding roof panel from the tilt position
8
Slacken torx bolts (5)
Torx bit set
-
See "Special Tools" below.
9
Insert cardboard strip (6) into seal joint at rear (see arrows)
NOTE: Cardboard strip (6): 500 mm long and approx. 2 mm thick.
10
Adjust tilting/sliding roof panel (1) in relation to exterior roof surface
-
Gap dimensions
-
Tilting/sliding roof panel, front: 0.15 mm
-
Tilting/sliding roof panel, at sides and rear: 0.30 mm
NOTE: Before adjusting the height, the tilting/sliding roof panel must always be closed from the tilt position.
-
Height adjustment: