mercedesbenz Workshop Repair Guides

Mercedes Benz Workshop Service and Repair Manuals

ABOUT US
AR35.20-P-0130B Remove/Install Rear Axle Shaft Flange and Angular Ball Bearing|Page 2467 > < AR35.20-P-0130B Remove/Install Rear Axle Shaft Flange and Angular Ball Bearing|Page 2465

E 420 (210.072) V8-4.2L (119.985) (1997)

Page 3
background image

b. Install puller/installer tool No. 124 589 05 43 00 or 140 589 08 43 00, or equivalents with attachments (08a, 08b, 08c and 08e) through

bearing as shown in the illustration

c. Pull bearing (8) from wheel carrier

INSTALLATION 

1. Assemble puller/installer tool with new bearing into wheel carrier as shown in the illustration
2. Pull two row angular ball bearing fully into wheel carrier
3. Insert locking snap ring into groove to retain bearing

4. Assemble puller/installer tool with axle shaft flange as shown in the illustration
5. Pull axle shaft flange into bearing
6. Install rear axle shaft, tighten twelve point collared nut to: 220 Nm

-

Stake twelve point collared nut to axle with with a suitable shop made tool

7. Install brake components
8. Install wheel

With Mechanical Puller

With Mechanical Puller

AR35.20-P-0130B Remove/Install Rear Axle Shaft Flange and Angular Ball Bearing|Page 2467 > < AR35.20-P-0130B Remove/Install Rear Axle Shaft Flange and Angular Ball Bearing|Page 2465