E 420 (210.072) V8-4.2L (119.985) (1997)
Figure 4
4. Install insert (A, Figure 3) into existing hole (arrow, Figure 4) in headrest arrester:
Note:
Installation is performed from inside of passenger compartment, through opening in section of interior body, which supports the rear seat back cushion.
-
Using needle nose pliers (needle nose pliers with 45 angle, if available) hold insert (A) in front of existing hole (arrow, Figure 4) in headrest
arrester.
Figure 5
-
Insert threaded bolt end (C, Figure 3) of tether anchor assembly, through hole (arrow, Figure 5) in headrest arrester from top (hat shelf side).
-
Thread tether anchor bolt (arrow, Figure 3) into insert until hand tight (while holding insert with needle nose pliers).
-
Using a wrench, seat insert (A, Figure 3) by tightening tether anchor bolt (arrow, Figure 3).
-
Repeat above installation on opposite side (include center position for model 210).