E 420 (210.072) V8-4.2L (119.985) (1997)
Shift Interlock Cable: Service and Repair
Remove/Install Ignition Lock Shift Interlock Cable
Removing and installing ignition lock shift lock cable
TRANSMISSION 722.6 in MODEL 220
Removing, installing
1
Disconnect ground cable from battery
2
Remove cover on center console
3.1 Remove communication/navigation
Note: With code 350a only
4
Remove center console
5
Unscrew fixing escutcheon on electronic ignition/starter switch control module
6
Pull electronic ignition/starter switch control module out of instrument panel
7
Press retaining lugs together (arrows) and move out shift lock cable on electronic ignition/starter switch control module in direction of arrow
Installation: Switch ignition lock to position "O".
Function test:
^
It should only be possible to shift the selector lever out of position "P" in ignition lock position "2" and when the brake pedal is depressed.
^
It should only be possible to remove the ignition key in selector lever position "P".
8
Unlock shift cable on electronic shift lever module control module
Note: Unlock retaining lugs in direction of arrow and pull off shift lock cable
9
Take shift lock cable out of instrument panel
Note: Do not damage sound deadening mat when removing.
10
Install in reverse order
Tools