E 420 (210.072) V8-4.2L (119.985) (1997)
Differential Mount: Service and Repair
REPLACEMENT
1. Remove rear axle center (differential) assembly (50). See: Service and Repair/Procedures
2. Replace rubber mounts of rear axle center assembly suspension as follows:
NOTE: Replace self-locking hexagon bolts and nuts
NOTE: Images depict arrangement on left side.
1. Pull both rubber mounts (62) forward and out of rear axle carrier using parts 15 and 16 of extractor/puller 210 589 02 43 00 (015, 016).
2. Pull both rubber mounts (62) into rear axle carrier using parts 07 and 15 of extractor/puller tool No. 210 589 02 43 00 until the puller disk (07)
rests against the rear axle carrier (arrow) (07, 015).
3. Install in reverse sequence.
NOTE: Check installed position of center assembly in rear axle carrier. See: Service and Repair/Procedures