E 420 (210.072) V8-4.2L (119.985) (1997)
/v8-4.2l_(119.985)/Page-1886004.png)
press the STEP button repeatedly until the display indicates Ready to measure the relevant angle.
5
Clean contact surfaces (arrows) for sensor (020a) on transmission.
6
Position sensor (020a) centrally on the three contact surfaces on the transmission (arrows) and press on firmly.
The spiral cable (020b) of the sensor (020a) must point in the direction of travel for each measurement. Otherwise the measurement will be
inaccurate.
Shown on model 203, 209
Measured Values Screen For Angle 1: Display E.G. 1.92 Degrees
The meter is ready to take a measurement. The value measured is shown on the display.
7
Press SAVE button. The values are saved.
Measured values screen for angle 1: display e.g. 1.92 degrees
Confirmation Screen
A Confirmation message appears briefly.
Confirmation screen
Ready Screen For Angle 2
