E 500 (211.070) V8-5.0L (113.967) (2004)
must then be repeated.
6. If one or both of the front axle brake calipers were replaced, then the pistons of the brake calipers must be moved before starting the bleeding
routine, as instructed below in steps a - b.
a. Using STAR Diagnosis follow the menu path: Control Units -> Chassis SBC-Sensotronic Brake System -> Actual Values -> Pressures
b. Install one pusher tool (W000 589 52 43 00) in place of each brake lining in the caliper, then slowly operate the brake pedal 5 times to extend
the brake piston up to the pusher tool and then push it back with the pusher tool.
NOTE:
This procedure is necessary to eliminate any free travel at the sealing ring.
Special Tools
NOTE:
The following allowable labor operations should be used when submitting a warranty claim for this repair. This information has been generated on
December 19, 2008. Please refer to Netstar -> Star TekInfo -> Star Time for the most current labor time allowance.
In Case of Warranty
Operation: Short test, perform (54-1011)
SBC system - check for air, perform (42-0653)
SBC system - check for air perform (42-0000)
Test program - after short test, perform (54-1012)
Battery charger connect (with SDS connected) (02-5058)
Hydraulic brake system bleed, perform (02-4566)
Hydraulic brake system bleed, perform (02-0000)
Technical Service Bulletin # P-42_46-43A
Date: 071101