E 500 (211.070) V8-5.0L (113.967) (2004)
NOTE:
-
Use a screwdriver to press out retaining clamp (11).
-
Installation: Install new O-ring.
5
Slacken bolts (2) of belt pulley (3)
NOTE: Installation: Tighten bolts
6
Remove poly V-belt
7
Detach the gas-operated spring (5) from the coolant pump (4) and turn it to the side
8
Detach the belt pulley (3) of the coolant pump (4)
NOTE: Installation: Screw in bolts (2) only by hand, do not tighten.
9
Dismount guide pulley (6)
NOTE: Lever off the cover (6a) with a screwdriver, remove the screw (4h).
10
Detach coolant hoses (7, 8)
CAUTION: Check condition of coolant hoses (7, 8) and hose clamps, replace if necessary.
11
Disconnect coolant hose (9) from oil-water heat exchanger
CAUTION: Check condition of coolant hose (9) and hose clamp, replace if necessary.
12
Detach and remove the coolant pump (4) from the timing case cover
CAUTION: Installation: Replace the gasket (4a).
13
Install in the reverse order
DANGER:
-
Risk of accident from vehicle starting off by itself when engine running. Risk of injury as working around the engine during start-up
or while running may result in contusions and burns
-
Secure vehicle to prevent it from moving.
-
Wear closed and tight-fitting work clothes.
-
Do not grasp hot or rotating parts.
14
Inspect cooling system for leaks.
CAUTION: See notes on coolant level.