E 500 (211.070) V8-5.0L (113.967) (2004)
DANGER:
-
Risk of accident. Accidents may result if the vehicle starts off unintentionally with the engine running. Risk of injury as working
around the engine during start-up or while running may result in contusions and burns.
-
Secure vehicle to prevent it from moving. Wear closed and snug-fitting work clothes. Do not grasp hot or rotating parts.
30
Run engine and inspect for leaks.
31
Bleed coolant system.
NOTE: Warm up the engine to normal operating temperature and fully open temperature regulator of heating (position "warm").
32
Inspect cooling system for leaks
NOTE: First of all, warm up engine to operating temperature.
33
Perform basic programming.
34
Read out fault memory with STAR DIAGNOSIS and erase if necessary.
AH01.40-P-1000-01B Notes on Application of Sealant Timing Case Cover
AH01.40-P-1000-01B Notes on application of sealant timing case cover
Component Identification
Application of sealant to timing case cover
The timing case cover is sealed with a silicone sealant at points A, C, D.
No sealant must be applied to the timing case cover at points B, pressure oil galleries to crankcase, with the exception around the bolt hole G. Sealant
which is applied to the points B, is entrained by the oil flow and blocks the oil supply drillings of: Main bearings, camshaft bearings, rocker arms and
oil spray nozzles.
Clean sealing surfaces
Apply sealant only to the specified surfaces with a bead of 2.0 mm ± 0.5 mm.
The sealant must be applied within 10 minutes!
The silicone bead must not be spread. Only the approved silicone sealant may be used.
AR01.40-P-8000-01B Screw Diagram For Timing Case Cover
AR01.40-P-8000-01B Screw diagram for timing case cover