E 500 4MATIC Wagon (211.283) V8-5.0L (113.969) (2004)
/v8-5.0l_(113.969)/Page-3455016.png)
Due to the short stroke of the press (010h) this process must be repeated approx. 5 times.
To do this, the piston is to be moved back by turning back the pressure screw (010k) and simultaneously tightening the hand wheel (068e). The
spindle of the hand wheel (068e) must always exert a little pressure onto the press (010h) so that the tools cannot fall out.
Component Identification
6
Insert the thrust piece (068d) and press out the rubber mount.
Install
Component Identification
Model 211, 215, 220, 230
7
Replace sleeve (068b) on bracket (068a) by sleeve (0680.
8
Insert rubber mount (6b) into hole in rear axle carrier.
9
Position removal insertion tool with thrust piece (068g) and press (010h) on rear axle carrier.
10
Fix the press (010h) and thrust piece (068g) in position by tightening the hand wheel (068e).
Pay attention to the chamfer (arrow) on the sleeve (068f) It must fit exactly against the rear axle carrier.
Component Identification
