mercedesbenz Workshop Repair Guides

Mercedes Benz Workshop Service and Repair Manuals

GF54.21-P-6030CA Rear SAM Control Unit With Fuse and Relay Module, Component Description|Page 7069 > < GF54.21-P-6030CA Rear SAM Control Unit With Fuse and Relay Module, Component Description|Page 7067
Page 3
background image

-

Exterior lights switch (model 207.3 up to 31.5.10)

-

Hazard warning flasher switch (S6/1s1)

Wiper/inside rearview mirror LIN

The processor responsible for controlling the basic functions reads in the signals from the following components over a wiper/inside rearview mirror
LIN:

-

Forward automatic mirror dimming light sensor (A67h1)

-

Rearward automatic dimming mirror light sensor (A67h2)

-

Garage door opener (A67n2) (with code (232) Garage door opener with frequency 284-390 MHz)

-

Rain/light sensor (/)B38/2

The communication with the processor responsible for controlling the central gateway functions can also send the data read in by the processor
responsible for controlling the basic functions to control units that are not connected to the interior CAN.

CAN

The processor responsible for controlling the basic functions reads in function-relevant data over the interior CAN.
Information from control units that are not connected to the interior CAN are sent by the processor responsible for controlling the central gateway
functions over the interior CAN. This can be information from control units, which are connected to one of the following CANs:

-

Chassis CAN

-

Front end CAN

-

Diagnostic CAN

The functions resulting therefrom are described in the corresponding function descriptions (see block diagram or function schematic).

Evaluation of input factors

The input factors are evaluated by the processor responsible for controlling the basic functions whereupon the corresponding components are then
actuated.

Control of systems

The processor responsible for controlling the basic functions manages the following systems:

-

ABL

-

Interior illumination (IBL)

-

Wiper system (WSA)

-

Windshield washer heater (with code (875) Heated windscreen washing system)

-

Headlamp cleaning system (with code (600) Headlamp cleaning system)

Component actuation

Components are actuated via the following lines:

^

Direct line

^

Instrument panel LIN

^

Wiper/inside rearview mirror LIN

Direct line

The following components are actuated over a direct line by the processor responsible for controlling the basic functions:

-

Refrigerant compressor (A9)

-

Left front lamp unit (E1)

-

Left daytime running lights headlamp (E1/3) (without code (498) Japan version)

-

Right front lamp unit (E2)

-

Right daytime running lights headlamp (E2/3) (without code (498) Japan version)

-

With code (498) Japan version or without code (615) Bi-xenon headlamp unit with integral curve illumination and without code (616) Bi-xenon
headlamp unit with integral asymmetrical curve illumination and without code (621) Intelligent Light System (left-hand traffic) and without code
(622) Intelligent Light System (right-hand traffic)
-

Left fog lamp (E5/1)

-

Right fog lamp (E5/2)

-

With code (494) Canada version or code (460) USA version
-

Left front side-marker lamp (E6/1)

-

Right front side-marker lamp (E6/2)

-

Glove compartment lamp (E13/1)

GF54.21-P-6030CA Rear SAM Control Unit With Fuse and Relay Module, Component Description|Page 7069 > < GF54.21-P-6030CA Rear SAM Control Unit With Fuse and Relay Module, Component Description|Page 7067