E 55 AMG Sedan (211.076) V8-5.5L SC (113.990) (2003)
^
Stop lamp feedback
^
Initialization, personalization, authenticity for stage 3 drive authorization system (DAS 3)
Central gateway control unit (N93)
^
Diagnosis request
The following information is sent via CAN-C:
Instrument cluster (A1)
^
Selector lever position for gear display (A1 p12)
CDI control unit (N3/9), with OM 642, OM 629
^
Selector lever position "P", "N"
ME control unit (N3/10), except OM 642, OM 629
^
Selector lever position "P", "N"
for EIS control unit (N73)
^
Selector lever position for actuation of backup lamp
^
Drive authorization system 3 messages (enable request)
Central gateway control unit (N93)
^
Selector lever position
^
Diagnosis request
Fully integrated transmission control (VGS) control unit (Y3/8n4)
^
Selector lever position
^
Transmission mode switch (S16/5)
GF27.19-P-5138-02NTL Control Unit For Electronic Selector Lever Module, Task
GF27.19-P-5138-02NTL Control unit for electronic selector lever module, task
The electronic selector lever module control unit (N15/5) receives analog and digital signals, it then actuates various components and sends
corresponding data to various control units over the Controller Area Network bus Class C (engine compartment) (CAN-C).
The selector lever positions and touch shifts carried out are detected in a non-contact manner by means of opto-electronic switches. A photoelectric
barrier is closed or interrupted each time the position of the selector lever is changed.
Internal input signals:
^
Selector lever position
^
Transmission mode switch status (S16/5)
^
Touch button ±
^
Voltage supply
Internal output signals:
^
R/P locking solenoid
^
Circuit 58d (shift-gate illumination)
The following information is received via CAN-C:
^
sent from the instrument cluster (A1)
-
circuit 58 dimmed
^
sent from the ESP control unit (N47-5)
-
Wheel speed and left rear direction of rotation
-
Wheel speed and right rear direction of rotation
-
Selected braking torque
^
sent from EIS [EZS] control unit (N73)
-
Circuit 50
-
Circuit 15
-
Status of stop lamp switch (S9/1)
-
Stop lamp actuation feedback
-
Drive authorization system, stage 3 (DAS [FBS] 3) message