E 55 AMG Sedan (211.076) V8-5.5L SC (113.990) (2003)
Interior Light Switch: Description and Operation
GF82.20-P-1003T Switching Switch and Controls Illumination On/Off, Function
GF82.20-P-1003T Switching Switch And Controls Illumination On/off, Function
The switch and controls illumination makes it easier to find the individual control panels, storage facilities and switches.
The switch and controls illumination is activated via the exterior lamp switch (S1) by manually switching on the parking or driving light, or automatically
if "night" was recognized via the rain/light sensor (B38/2) and the instrument cluster (A1). The function of automatic driving light must be activated.
The following are switched on or off under the same conditions:
^
Left rear ashtray illumination (E9/8)
^
Right rear ashtray illumination (E9/9)
^
Illumination (R3e1)
^
Right front footwell lamp (E17/15)
^
Left front footwell lamp (E17/16)
^
Right rear footwell lamp (E17/17)
^
Left rear footwell lamp (E17/18)
Switching off is effected immediately after taking back the requirements stated or in the event of undervoltage or overvoltage.
Actuation of the remaining lamps
This is performed via the rear SAM control unit with fuse and relay module (N10/2), as soon as it receives the CAN message Duty cycle of terminal 58d
> 5 % from the instrument cluster (A1).
Dimming of symbol lighting
When the standing lamp is switched on, the symbol lighting also remains switched on permanently and is dimmable. The function indicator lamps are not
dimmable.
With the exception of illumination (R3e1), the illumination is provided by LEDs.
Only the switch lighting can be dimmed. The setting is performed using the instrument lighting dimmer and reset button (A1r1).
The parking lamp has no influence on the symbol and function illumination.
In Model 211.6, depending on equipment and special body, the number and position of the interior lamps may vary.
GF82.20-P-2007T Switch Interior Lighting on By Means of Anti-Theft Alarm, Function
GF82.20-P-2007T Switch Interior Lighting On By Means Of Anti-Theft Alarm, Function
Function
If the anti-theft alarm system (ATA [EDW]) has triggered an alarm, the front dome lamp (N70e1) and the rear interior lamp (E15/3) are switched on
without dimming.
If the alarm is canceled, the front dome lamp (N70e1) and the rear interior lamp (E15/3) are switched off again.
In Model 211.6, depending on equipment and special body, the number and position of the interior lamps may vary.
Actuation of interior lamps
In the event of an ATA alarm, the message "switch on interior lamp - ATA" is placed on the interior CAN by the rear SAM control unit (N10/2).
The overhead control panel control unit (N70) reads this message and actuates the front dome lamp (N70e1) and the rear interior lamp (E15/3).