E 55 AMG Sedan (211.076) V8-5.5L SC (113.990) (2003)
Headlamp Washer Pump: Service and Repair
AR82.35-P-6003T Remove/Install Headlamp Cleaning System Pump
- with CODE (600a) Headlamp cleaning system
Shown On Model 211.0
1
Disconnect ground cable of battery
DANGER:
-
Risk of death. Death may result if vehicle slips or topples from the lifting platform.
-
Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified
by the vehicle manufacturer.
2
Lift vehicle on lifting platform.
3
Remove right front wheel
-
Wheel bolt: 130 N.m
4
Remove rear fender liner in right front fender
5
Disconnect electrical connectors (1)
6
Detach electrical connector on rear-end door washer fluid pump
7
Disconnect the washer fluid hose from the HCS pump (M5/2)
NOTE:
-
To do so press locking clamps together (arrow). Collect washer fluid which flows out.
-
Installation:Replace sealing ring (3)
8
Unclip bracket (4) from washer fluid reservoir (5)
9
Use a mounting wedge to push off the HCS pump (M5/2) from the washer fluid reservoir (5)
NOTE: Note correct installation position.
See "Special Tools" given below.
NOTE: Installation:Install new gasket (6)
10
Install in the reverse order