E 55 AMG Wagon (211.276) V8-5.5L SC (113.990) (2006)
CAUTION: Protect air conditioning circuit and components from moisture when carrying out repair work.
1
Drain air conditioning (recycle)
NOTE: Note quantity of extracted compressor oil.
CAUTION: Installation: Incorrectly filled compressor oil quantity may result in damage to the refrigerant compressor.
NOTE: Installation: Evacuate and fill air conditioning system, adding new compressor oil to refrigerant circuit using the noted compressor oil
quantity. Check air conditioning system for leakage.
2
Remove right-hand fanfare horn (H2/1)
3
Remove charge air cooler
-
On MODELS 211.004/006/016/026/028/206/216/226
4
Unscrew mounting screws for the brace (4), press top of air guide (9) downward and remove brace (4)
NOTE: Installation: Do not trap engine hood cable between the brace (4) and radiator crossmember (3).
5
Remove body-bound rivets (2) on the left and right side and remove top of the air dueling (9) with the intake connector (8)
6
Unclip holders (6) for oil line (5) from latching hooks at left and right sides of radiator
NOTE: Do not snap off latching hooks.
7
Put down oil line (5) with oil cooler to front
8
Unclip holder (7) from condenser (1) out of latching hooks at left and right sides of radiator and tilt condenser (1) forward
NOTE: Do not snap off latching hooks.
9.1 Remove lower front engine compartment paneling
-
On MODELS 211.042 /043 /061 /065 /070 /076 /080 /082 /083 /242 /243 /261 /265 /270 /276 /280 /282 /283
9.2 Remove bottom section of noise encapsulation at the front.
-
On MODELS 211.004/006/016/026/028/206/216/226
10
Remove body-bound rivets (14) from lower air dueling (10)
11
Unclip latching hooks (11) on left and right sides of radiator and lead out the lower air dueling (10)
NOTE: Note installation position of lower air dueling (10).
12
Unscrew nut (13) and place refrigerant lines to one side
NOTE: Seal line openings, otherwise dirt and moisture may penetrate.
-
Set of plugs for air conditioning system
See "Commercially Available Tools" given below.
NOTE: Installation: Install new sealing rings and moisten thread with compressor oil.
-
Pressure and hot gas line to capacitor: 8 N.m
13 Guide condenser (1) downward out of guides on radiator and remove
-
Additional oil filling capacity when replacing the condenser: 30 cu.cm
-
For Refrigerant compressor 7SEU16C
14 Replace fluid reservoir (12)
15 Install in the reverse order.
Commercially Available Tools