mercedesbenz Workshop Repair Guides

Mercedes Benz Workshop Service and Repair Manuals

GF83.40-P-2180-01T Automatic Air Conditioning Control and Operating Unit, Task|Page 15225 > < Control Panel Rear Switch Group|Page 15222
Page 1
background image

Control Assembly: Description and Operation
GF83.40-P-2180-01T Automatic Air Conditioning Control and Operating Unit, Task

GF83.40-P-2180-01T Automatic Air Conditioning Control And Operating Unit, Task

- 211.0/2 up to 31.5.06
- with CODE (581) Comfort automatic air conditioning

Component Identification

The AAC [KLA] control and operating unit (N22) is responsible for the following tasks:

^

Switch automatic air conditioning (AAC [KLA]) on and off

^

Interior compartment temperature selection cold/warm separate for left and right sides

^

Manual blower control

^

Manual air distribution

^

Automatic blower control and air distribution

^

Air recirculation mode

^

Defrost function

^

Heated rear window actuation

^

Residual engine heat utilization system

^

Refrigerant compressor shutoff

The AAC [KLA] control and operating unit (N22) is used to actuate the following:

Via the Control Area Network bus, class B (interior compartment) (CAN B):

-

refrigerant compressor

-

Heat exchanger shutoff motor

by the driver-side SAM control unit with fuse and relay module
-

coolant circulation pump

by the passenger-side SAM control unit

Via Controller Area Network bus class C (engine compartment) (CAN-C):

-

engine and air conditioning electric suction fan with integrated control via the central gateway control unit, through the CDI control unit (with
diesel engine) or the ME-SFI [ME] control unit (with gasoline engine)

Via local interconnect network (LIN):

-

Blower regulator

-

Fresh air/air recirculation flaps actuator motor

-

Left blend air flap actuator motor

-

Right blend air flap actuator motor

-

Left and right footwell flaps actuator motor

-

Left and right defroster flaps actuator motor

-

Center outlet flap actuator motor

-

Heater booster (with engine 271, 628, 629, 642, 646, 647 and 648)

The following sensor signals are read in by the AAC control and operating unit (N22):

^

Directly:
-

in-car temperature sensor

-

evaporator temperature sensor

GF83.40-P-2180-01T Automatic Air Conditioning Control and Operating Unit, Task|Page 15225 > < Control Panel Rear Switch Group|Page 15222