mercedesbenz Workshop Repair Guides

Mercedes Benz Workshop Service and Repair Manuals

Sensors and Switches - Exhaust System > < Procedures|Page 5611
Page 3
background image

NOTE:  Use lubricant

Inspect

5

Check exhaust rubber mounts (9/1, 9/2) for wear and damage.

NOTE:  Check for wear, replace if required.

Install

6

Hang left rear muffler (9a) into exhaust rubber mounts (9/1, 9/2)

NOTE:  Use lubricant

7

Loosely screw down left and right rear muffler (9a, 9b) by means of bracket (11/8) and bolt (11/7)

8

Align left rear muffler (9a) and screw down with clamp (9c) at center muffler (10)

9

Tighten nut (11/7)

Right muffler

10

Remove center muffler (10) with right rear muffler (9b)

NOTE:  The right rear muffler cannot be replaced separately and must be replaced together with center muffler, Replace center muffler

Inspect

11

Inspect installation position and clearance o1 exhaust system

NOTE:  The exhaust system must be installed free of stress, if necessary, Align exhaust system.

DANGER:
-

Risk of accident. Accidents may result if the vehicle starts off unintentionally with the engine running. Risk of injury as working
around the engine during start-up or while running may result in contusions and burns.

-

Secure vehicle to prevent it from moving. Wear closed and snug-fitting work clothes. Do not grasp hot or rotating parts.

12

Conduct engine test run and inspect exhaust system for leaks.

Sensors and Switches - Exhaust System > < Procedures|Page 5611