E 63 AMG Sedan (211.077) V8-6.3L (156.983) (2007)
Measuring
8
Measure and note total friction torque of drive pinion
9
Slacken and unscrew hexagon collared nut (40)
NOTE:
-
Do not remove the collar protection when slackening the hexagon collared nut.
-
To improve control when slackening the hexagon collared nut, press the shop-made bush into the commercially available socket wrench
bit.
CAUTION: Installation:
-
Replace hexagon collared nut and tighten in stages until the friction torque previously measured is achieved.
-
Observe minimum tightening torque, if necessary. If tightening torque is not achieved, Replace rear axle center assembly.
-
Secure hexagon collared nut on drive pinion joint flange.
10
Pull off joint flange (41)
NOTE: Use puller if necessary.
11
Lever radial sealing ring (42) out of rear axle center assembly (50) using a suitable tool
CAUTION: Installation: Replace radial sealing ring, coat sealing lip with universal hypoid gear oil and press into rear axle center
assembly using drift.
12
Install in the reverse order
13
Check rear axle center assembly oil level and correct if necessary
14
Activate SBC brake system using STAR DIAGNOSIS
15
Use STAR DIAGNOSIS to move brake pads toward brake discs.