G 500 (463.249) V8-5.0L (113.962) (2003)
/v8-5.0l_(113.962)/Page-1368001.png)
Seat Bottom Frame: All Technical Service Bulletins
Interior - Noises From The Front Seat Trim
Date: June 4, 2008
Order No.: T-B-91.10/164
Supersedes:
Group: 91
SUBJECT:
Model 463.246/249/271, As of VIN X123094
Noises from Seat Trim
If you receive customer reports in the above model vehicles of noises from the seat trim when the seat is moved all the way back, which results in
insufficient clearance between the seat frame and the B-pillar, this causes the seat trim to touch the B-pillar. Follow the steps below to correct.
1.
Drill a new hole (3.0 mm diameter) at a distance of 7 mm toward the front from the original hole in the seat frame shown in Figure 1, pos. 1.
2.
Remove the fastening lug on the seat trim and drill a hole (3.5 mm diameter) shown in Figure 1, pos. 2.
3.
Connect the seat trim to the new hole using a 3.5 x 13 sheet metal screw (N000000 000447).
Parts Information
Note:
The following allowable labor operations should be used when submitting a warranty claim for this repair. This information has been generated on
June 4, 2008. Please refer to Netstar --> Star TekInfo --> Star Time for the most current labor time allowance.
In Case of Warranty, use the table.
