GL 320 BLUETEC (164.825) V6-3.0L DSL Turbo (642.820) (2009)
/v6-3.0l_dsl_turbo_(642.820)/Page-1694001.png)
Brake Pad Wear Sensor: Service and Repair
AH42.10-P-0003-01GZ Notes on installing brake pad wear sensor contact sensors
Component Identification
^
When replacing the brake pads the left front brake pad contact sensor (S10/1), the right front brake pad contact sensor (S10/2) and the right rear
brake pad contact sensor (S10/4) must also be replaced.
^
The left front brake pad contact sensor (S10/1), the right front brake pad contact sensor (S10/2) and right rear brake pad contact sensor (S10/4)
may only be mounted on the inner brake pads.
^
The electrical feed line of the contact sensors must be routed as shown in the picture.
^
Check the correct latching of the left front brake pad contact sensor connector (S10/1x1), right front brake pad contact sensor connector (S10/2x1)
and right rear brake pad contact sensor connector (S10/41).
Engrossing moisture can result in the warning lamp lighting up.
