GL 320 BLUETEC (164.825) V6-3.0L DSL Turbo (642.820) (2009)
Constant Velocity Joint Boot: Service and Repair
Rear Axle
AR35.30-P-0665-02GZ Detaching and attaching rubber boots at joint
Rear Axle Shaft
Component Identification
Removal:
1
Remove large hose clamp (shown with tensioning lug) (5, 9) and small hose clamp (7, 11) using side cutting pliers.
2
Pull off rubber boot.
Component Identification
Installation
3
Scrape grease off inside of rubber boot and pack into joint; replace grease if necessary. Observe filling quantity.
4
Push new rubber boot into correct position.