GL 320 CDI (164.822) V6-3.0L DSL Turbo (642.940) (2008)
3.
SCN code engine control module:
Continue with menu item: Control unit programming and follow on screen instructions.
Note:
For information on SCN coding, refer to service bulletin: S-B-58.00/144b
B.
CHECK TRANSMISSION CONTROL MODULE SOFTWARE AND UPDATE IF NECESSARY
1.
Check software release of electronic transmission control module:
^
Follow DAS path: Control units/Drive/Transmission/Electronic transmission control/Control unit adaptations/Control module
programming.
^
If software release A 006 448 7810 is not present proceed to step 2.
^
If software release A 006 448 7810 is present proceed to step 3.
Note:
SCN coding of the engine control module must be performed prior to proceeding with the following steps.
2.
Install electronic transmission control module software and perform SCN coding:
^
Install electronic transmission control module software from hard disc:
Follow DAS path: Control module programming and follow on screen instructions.
^
SCN code transmission control module:
Continue with menu item: Control module programming and follow on screen instructions. Procedure is now completed.
3.
SCN code transmission control module:
Follow DAS path: Control module/Drive/Transmission/ETC Electronic transmission control/Control module adaptations/SCN coding.
Note:
The following allowable labor operation should be used when submitting a warranty claim for this repair:
Warranty Information