mercedesbenz Workshop Repair Guides

Mercedes Benz Workshop Service and Repair Manuals

Keyless Start Transmitter|Description and Operation|Page 11097 > < Keyless Start Antenna|Service and Repair|Page 11093
Page 1
background image

Keyless Start Transmitter: Description and Operation

GF80.57-P-6010GZ Transmitter key, component description

-

up to Model year 8

Component Identification

Design

The transmitter key consists of an electronic key and a mechanical key (7). The electronic key contains an FM radio transmitter, an infrared
transmitter/receiver, a computer chip and transmitter button (1, 2, 3, 6) as well as two button cells.The mechanical key (7) can be unlocked and removed
with the unlock slider (5).

Locking central locking (CL)

-

Actuate "Lock" transmitter button (1):

-

Press once (locking CL globally) Press and hold down while pointing at IR receiver (convenience closing)

Unlocking central locking (CL)

Actuate "Unlocking" (2) transmitter button

-

Pressing once when set to "Selective" (driver door and fuel filler flap are unlocked)

-

Press once when set to "global" (unlocks all)

-

Press twice when set to "selective" (unlocks all) Press and hold down while pointing at IR receiver (convenience closing)

On USA version, code 494 two IR receivers are installed. Left front IR receiver (A26/1) and right front IR receiver (A26/2).

Switches unlocking from "selective" to "global" or vice versa

-

Hold "Lock" button (1) and "Unlock" button (2) simultaneously for approx. 5 s until the "Battery control" LED (4) flashes twice.

Panic alarm

With radio remote control with panic switch, code 763 Actuate "Panic alarm" (6) transmitter button:

-

Press approx. 2 s (trigger panic alarm)

-

Press approx. 0.5 s (terminate panic alarm)

Open/close rear-end door transmitter button (RWTS)

Actuate "Rear-end door closing" transmitter button (3)

-

Press approx. 0.5 s (open/close trunk lid)

Drive authorization stage 3 (DAS 3)

When the transmitter key is inserted into the EIS control module, it is supplied with power via an induction coil. Data is exchanged via the infrared
transmission and receiving unit for the purpose of verifying drive authorization.

Unlock/lock vehicle doors or unlock trunk lid

When the transmitter button (1, 2 or 3) is pressed, a radio signal is transmitted by the transmitter key. Parallel to the radio signal, an infrared signal is
transmitted to the IR receiver If the signal is valid, the vehicle doors are unlocked or lock and the trunk lid is unlocked

Mechanical key

The mechanical key (7) can be removed from the transmitter key after actuating the unlock slider (5). When the driver door is unlocked with the
mechanical key (7) the CL is not actuated

An alarm is not triggered on vehicles with anti-theft alarm system (ATA) code 551.

Keyless Start Transmitter|Description and Operation|Page 11097 > < Keyless Start Antenna|Service and Repair|Page 11093