GLK 350 4MATIC (204.987) V6-3.5L (272.971) (2010)
Emergency Contact Module: Description and Operation
GF82.95-P-2010CEU MB Information, Function
GF82.95-P-2010CEU MB Information, Function
- with CODE (359) TELE AID emergency call system
Function requirements, general
^
C. 30 ON
^
Telematic Alarm Identification on Demand (emergency call system) (TELE AID) system authorized and operating error-free
^
The vehicle-related MB-Info call service is separately authorized
^
An emergency call system control unit (N123/4) communication module authorized for the vehicle-related MB-Info call service is configured
ex-factory with the telephone number of the corresponding service provider
^
The customer is registered and authorized in the Customer Assistance Center (CAC)
^
A mobile telephone network available in adequate strength and quality
^
Triggering of an MB-Info call through pressing the MB-Info button (S93/6s1) > 0.5 s
^
A higher-priority vehicle-related service is not active
Depending on the equipment installed one of the following control units will be installed, referred in the following text as audio equipment":
-
Radio (A2) (with code (523) Radio MB Audio 20 or code (510) Audio 20 incl. CD changer)
-
COMAND control unit (A40/3) (with code (512) COMAND APS incl. DVD changer or code (528) COMAND incl. DVD changer)
MB-Info, general
The MB-Info call function enables the customer to call up information on Mercedes-Benz brand products as well as further voice-based services (e.g.
hotel booking).
For example, it provides information on the following services:
-
Current traffic conditions
-
Technical questions, complaints and services
-
Mercedes-Benz products and Mercedes Card
-
Leasing and financial offers
This vehicle-related service is primarily an oral information service that is provided via the communications module integrated into the emergency call
system control unit.
The MB-Info call function consists of the two following subfunctions:
^
MB-Info call function sequence
^
Function sequence for display of additional services
MB-Info call function sequence
The status of the MB-Info button is read in by the emergency call system control unit over a direct line.
The emergency call system control unit automatically transmits an SMS with the following data via the integrated communication module to the CAC:
-
Vehicle position
-
Customer identification data
-
Vehicle identification data
Additionally, the communication module integrated into the emergency call system control unit sets up a voice communication to the CAC.
The communication module integrated into the emergency call system control unit transmits and receives the mobile phone signals or data in the
following way:
-
Direct line
-
Frequency switchover control unit (N96) (with code (389) Mobile phone preinstallation with universal interface, USA/Canada, and direct line
-
Multifunction antenna (A28/11)
The MB-Info button's integrated light emitting diode (LED) flashes as long as the MB-Info call is activated.
In the event of an MB-Info call, other vehicle-related services (e.g. vehicle remote door unlock) and, for vehicles with code (389) Mobile phone
preinstallation with universal interface, USA/Canada, any active mobile phone connections are interrupted.
In the event of a multifunction antenna malfunction (e.g. defective because of rollover) the emergency call system control unit automatically uses the
emergency call system antenna (A2/52) to transmit mobile phone signals or data.
Function sequence for display of additional services
Also available are the following services which are shown on the Audio/COMAND display (A40/8):
-
Destination Feed In (transmission of destinations that can then be activated through the navigation system)
-
Freetext (transmission of text messages)