GLK 350 4MATIC (204.987) V6-3.5L (272.971) (2010)
Trunk / Liftgate Stop: All Technical Service Bulletins
Campaign - Adjust Rear Lift Gate Stops
FILE:
SERVICE: GROUP 00 OF SERVICE INFORMATION BINDER
PARTS: GROUP I OF INFORMATION _ PARTS & ACCESSORIES BINDER
Campaign No. 2009110004, December 2009
TO: ALL MERCEDES-BENZ CENTERS
SUBJECT:
Model 204.9, Model Year 2010
Adjust Rear Lift Gate Stops
This Service Campaign has been initiated because Daimler AG (DAG), the manufacturer of Mercedes-Benz vehicles, has determined that the rear lift
gate stops may not be adjusted to specification. If the stops are not adjusted properly, the rear lift gate may contact the body when driving on uneven
roads. Dealers will adjust the rear lift gate stops at the next workshop visit.
Prior to performing this Service Campaign:
^ Please check VMI to determine if the vehicle is involved in the Campaign and if it has been previously repaired.
^ Please review the entire Service Campaign bulletin and follow the repair procedure exactly as described.
Please note that Recall and Service Campaigns do not expire and may also be performed on a vehicle with a vehicle status indicator.
Approximately 14,203 vehicles are affected.
Procedure
1. Adjust both stop buffers (arrows, Figure 1) on rear lift gate to 7 mm using a feeler gauge (A) and torx driver (B).